| Forums | Sign Up | Reply | Search | Statistics | Home Page |
Online now: Guests - 1
Members - 0
Most users ever online: 7 [14 Nov 2018 12:52]
Guests - 7 / Members - 0
Integrex Programming EIA integrexmachinist.com community built on miniBB / Integrex Programming EIA /

Y axis error

 
RICHY85
Forums Member
#1 | Posted: 5 Nov 2018 23:54
Reply 
Good Morning.

I'm machining a part using EIA programs on our Integrex 300 IV ST. I'm machining it at C0 down to just below the centerline then rotating to C180 and machining down below the centerline again.

Where the two programs blend there is about a 0.05mm mismatch in the Y axis. Does anybody know how I can run my EIA program with a offset in my Y axis?

Kind Regards,
Richard.
 

:);):-p:-(More smilies...  Disable smilies in post
Your reply
Bold Style  Italic Style  Image Link  URL Link 

» Username  » Password 
Only registered users are allowed to post here. Please enter your login/password details upon posting a message, or sign up first.
 

Forums are powered by miniBB®