G84.2 cycle HD2

Just wondering if anyone has had issues using the rigid tap cycle (G84.2) on HD2. We can only get the tap to feed in spinning in reverse and retract spinning forward, Not good. Commanding M203 or M204 has no effect. G84 works as expected. Here is my code. I am using G12.1 as well. I'll have to test if that has anything to do with the issue.

N02642 ()
N02643 (******************** M6_TAP ********************)
N02644 ()
N02645 G28 U0.
N02646 G28 V0. W0.
N02647 G28 B0.
N02648 M902
N02649 M300
N02650 G110C2
N02651 G122.1
N02652 T10 T28 M6 (*** TAP_M6 *** D5.00000000000000000 mm ***)
N02653 M250
N02654 G0 B180.
N02655 M251
N02656 G53.5 Z#9101+#510 C#9102+#508
N02657 M312
N02658 G0 C0.0
N02659 M311
N02660 G97 S200 M203 M8 M153 (M203 or M204 yields the same results)
N02661 G0 C0.
N02662 G17UH
N02663 G12.1
N02664 G122.1
N02665 ( Polar Output )
N02666 X-36. C0.0 Z-54.5
N02667 G99 G84.2 X-36. C0.0 Z-39.5 R0.0 F1. (Feeds into the hole spinning in reverse and exits spinning forward)
N02668 G84.2 X36. C0.0 Z-39.5 R0.0 (Feeds into the hole spinning in reverse and exits spinning forward)
N02669 G80
N02670 M9 M154
N02671 G0 X150. C0.
N02672 G13.1
N02673 G28 U0.
N02674 G0 C0.0
N02675 G111.
N02676 (Step Run Time 0.48 Minutes)
N02677 (Total Run Time 14.96 Minutes)

I had that problem had to use G68.5 to get it to work right.

I was kind of thinking it had something to do with polar interpolation. I'm checking with Mazak if there is any software updates to fix this issue.

Thanks for your input

I do it all the time but only in Mazatrol and have never noticed an issue. I'd post the mazatrol file, and single block through the program and watch the EIA commands it throws past in the buffer. That will give you the format it is looking for in EIA.

Stu

you need to put the m203 or m204 on the same line as the tap call g84.2