backup battery's

| Forums | Sign Up | Reply | Search | Statistics | Home Page |

	integrexmachinist.com community built on miniBB / Integrex General /
backup battery's

latheguy Forums Member	#1 \| Posted: 8 Feb 2010 12:58 Reply
We have an integrex 200 mark 4 and were wondering if these machines use backup battery's. On our other 2 axis lathes, we have D-cell battery's that need replacement on occasion. I know about the servo drive backup battery's, but are there any battery's to backup the control?

Mazak123 Forums Member	#2 \| Posted: 8 Feb 2010 13:28 Reply
No batteries on the control.

MikiMajk Forums Member	#3 \| Posted: 9 Feb 2010 00:42 \| Edited by: MikiMajk Reply
I thnik it is. It's on HN163 card. Normaly it holds tha data for 5 years(6) and then you will get alarm battery malfunction. Then you have 1 week to exchange the battery. MM

Mazak123 Forums Member	#4 \| Posted: 9 Feb 2010 07:54 Reply
You're right, my bad. On the fusion control, the HR081 board, on the Matrix, it's located behind the little 7-segment displys. Not sure what board # it is,

MikiMajk Forums Member	#5 \| Posted: 9 Feb 2010 08:58 \| Edited by: MikiMajk Reply
Mazak123, it goes to the main NC card HN163, it/s logical. Haven/t you been at Mitsubishi Traning courses? MM

latheguy Forums Member	#6 \| Posted: 9 Feb 2010 17:04 Reply
Thanks guy's!

Mazak123 Forums Member	#7 \| Posted: 10 Feb 2010 16:33 Reply
MikiMajk, yes I have been. What's your point?

MikiMajk Forums Member	#8 \| Posted: 11 Feb 2010 08:12 Reply
My point is that you then know a lot of things that i don't. MM

Forums are powered by miniBB®